WEBVTT FILE

Step 15
00:00:01.000 --> 00:00:13.000 line:16 position:50% align:center size:100%
Loosen screws, 2 screws TX 20.

Step 16
00:00:13.000 --> 00:00:17.000 line:16 position:50% align:center size:100%
Remove the cover.

Step 17
00:00:17.000 --> 00:00:27.000 line:16 position:50% align:center size:100%
Only break out as many target break points as there are cables.

Step 18
00:00:27.000 --> 00:00:35.000 line:16 position:50% align:center size:100%
Disconnect the connection to the PV modules.

Step 19
00:00:35.000 --> 00:00:42.000 line:16 position:50% align:center size:100%
Observe the maximum length and diameter of the cables.

Step 20
00:00:42.000 --> 00:00:50.000 line:16 position:50% align:center size:100%
Use cables with the same diameters.

Step 21
00:00:50.000 --> 00:00:57.000 line:16 position:50% align:center size:100%
Thread in the PV+/PV- cables.

Step 22
00:00:57.000 --> 00:01:00.000 line:16 position:50% align:center size:100%
Pull back the PV cables by 2 cm ... 

Step 23
00:01:00.000 --> 00:01:04.000 line:16 position:50% align:center size:100%
... so that the rubber seals are bulging out.

Step 24
00:01:04.000 --> 00:01:10.000 line:16 position:50% align:center size:100%
Connect PV+/PV- cables to the appropriate terminal point.

Step 25
00:01:10.000 --> 00:01:21.000 line:16 position:50% align:center size:100%
Secure the connected cables with a screwdriver. Observe the printed torque data!

Step 26
00:01:21.000 --> 00:01:39.000 line:16 position:50% align:center size:100%
Secure the cover. 2 x TX 20 screws.

Step 27
00:01:39.000 --> 99:59:59.999 line:16 position:50% align:center size:100%
Connect PV modules. Caution! DC voltage! Note +/-!